Introduction

This is an easy guide. It should only take a few minutes to complete and it doesn't require any tools.

Tools

No tools required.

Parts

No parts required.

  1. Lay the Roomba upside down on a flat surface with the blue strip away from you.
    • Lay the Roomba upside down on a flat surface with the blue strip away from you.

    Add Comment

  2. Use your index fingers to pull the yellow tabs towards you.
    • Use your index fingers to pull the yellow tabs towards you.

    • While still pulling the yellow tabs with your index fingers, tilt up the brush guard.

    • For reassembly, make sure to push in the brush guard until it clicks into place.

    Add Comment

    • Pull back the brush guard to unhook it from the latches.

    • Remove the brush guard by lifting it up and out of the Roomba.

    • This picture has a change in orientation to illustrate the latches. Continue disassembling the Roomba with the blue strip away from you.

    Add Comment

    • Set the brush guard aside.

    • The main brush is the bristly one that is closest to the blue strip.

    Add Comment

    • Remove the main brush by grabbing it and pulling it up and out of the Roomba.

    • For reassembly, orient the Roomba with the battery closest to you:

      • First, insert the black end of the main brush into the black square opening on the right side.

      • Second, lay the main brush back into place.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Samantha Barrett

Member since: 01/13/2014

501 Reputation

5 Guides authored

Team

Cal Poly, Team 17-5, Forte Winter 2014 Member of Cal Poly, Team 17-5, Forte Winter 2014

CPSU-FORTE-W14S17G5

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 398