Skip to main content

Fix Your Stuff

Right to Repair

Store

Introduction

If the filter on your iRobot Braava Jet 240 needs to be replaced, follow this guide.

The filter is located between the tank cover and the tank. The filter catches any residue that is in the water, ensuring that the iRobot Braava Jet 240 only sprays clean water. If the filter collects too much dirt, it needs to be removed and cleaned. The filter could also tear, in which case it should be replaced.

  1. Turn the device off.
    • Turn the device off.

  2. Use your fingers to gently pop out the battery. Use your fingers to gently pop out the battery.
    • Use your fingers to gently pop out the battery.

  3. Lift the handle to access the filter. Lift the handle to access the filter.
    • Lift the handle to access the filter.

  4. Pull up the filter cover. Pull up the filter cover. Pull up the filter cover.
    • Pull up the filter cover.

  5. Insert your finger into the filter and pull it up to remove it from the device. Insert your finger into the filter and pull it up to remove it from the device. Insert your finger into the filter and pull it up to remove it from the device.
    • Insert your finger into the filter and pull it up to remove it from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Claire Franz

Member since: 02/10/2020

1,385 Reputation

7 Guides authored

Team

Cal Poly, Team S22-G2, Regan Winter 2020 Member of Cal Poly, Team S22-G2, Regan Winter 2020

CPSU-REGAN-W20S22G2

5 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 11

Past 30 Days: 47

All Time: 484