iPod Touch 4th Generation speaker soldering
Tysl332 and 3 other contributors
Last updated on Feb 19, 2016
Views: 7.5K
View statistics:
- Past 24 Hours:
- 3
- Past 7 Days:
- 25
- Past 30 Days:
- 93
- All Time:
- 7,523
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 3 4
3 people have marked this guide "completed." Will you be next?
4 people have marked this guide "completed." Including you — great job!
Favorites: 14 15
14 people have favorited (and subscribed to) this guide. Will you be next?
15 people have favorited (and subscribed to) this guide — including you!
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
Introduction
Go to step 1 ↓This guide will help you in identifying the soldering joints locations for the loud speaker on the iPod Touch 4th Generation
What you need
Parts
Tools
-
-
-
-
Flush Cutter$15.954.9
to strip the wires, of existing loud speaker unless you've got a replacement
-
-
-
-
I've boxed where the ribbon cable connectors go for the screen and camera.
-
The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires.
-
The second picture shows the wires soldered to the logic board.
-
The loud speaker replacement was very tedious job.. anyways Good Luck
Ask FixBot
-
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
