iPod Touch 4th Generation Upper Logic Board Replacement

Step 1 Upper Logic Board

• Remove the following three screws near the top edge of the logic board:
• One 2.0 mm Phillips screw
• Two 2.3 mm Phillips screws
Step 2

• Use the edge of an iPod opening tool to gently pry, but not remove, the rear-facing camera away from the rear case.
• Do not attempt to remove the rear-facing camera yet.
Step 3
• Use an iPod opening tool to slightly lift the edge of the logic board next to the battery enough to grab it with your other hand.
• Do not excessively bend the logic board, as it is very thin and fragile.
• Be very careful not to lift too much as the volume control ribbon cable is still connected and will tear very easily.
• While gently lifting the logic board with one hand, use an iPod opening tool to lift the logic board near the copper tape at the logic board's top edge.
• The logic board will be lifted adequately when the last display assembly connector has cleared the top edge of the rear case.

Author

with 8 other contributors

Walter Galan

694,825 Reputation

1,203 Guides authored

Badges: 54

• 
• 
• 

+51 more badges

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview