Skip to main content

Shop the Holiday Gift Guide
Free Shipping on Domestic Orders $75+

iPod Touch 2nd Generation Power/Volume Controls Replacement

Views: 2.8K

View statistics:

Past 24 Hours:
0
Past 7 Days:
2
Past 30 Days:
11
All Time:
2,781
Comments: 0

No one has left comments on this guide. Will you be first?

Go to guide comments
Completed: 0

No one has marked this guide "completed." Will you be the first?

Favorites: 0

No one has favorited (and subscribed to) this guide. Will you be the first?

Time Required: No estimate
Difficulty: Difficult
Prerequisite Only

This is a prerequisite-only guide! This guide is part of another procedure and isn’t meant to be used alone.

iPod Touch 2nd Generation Power/Volume Controls Replacement

Introduction

Go to step 1 ↓

This guide is an internal private guide used as a prereq.

What you need

Tools

  • Phillips #00 Screwdriver
    4.9
  • Spudger
    4.9
    1. iPod Touch 2nd Generation Power/Volume Controls Replacement, Power/Volume Controls: step 1, image 1 of 1
      • Remove the two Phillips screws securing the power/volume controls to the rear panel.

      Ask FixBot

      Add Comment

    2. iPod Touch 2nd Generation Power/Volume Controls Replacement: step 2, image 1 of 1
      • Use the tip of a spudger to remove the yellow kapton tape covering the power/volume control ribbon cable.

      Ask FixBot

      Add Comment

    3. iPod Touch 2nd Generation Power/Volume Controls Replacement: step 3, image 1 of 1
      • Remove the two Phillips screws securing the power/volume controls to the rear panel.

      • Lift the power/volume controls out of the rear panel.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

with

Walter Galan

711,950 Reputation

1,203 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 11

All Time: 2,781