iPhone 7 Logic Board Disconnection

Use the flat end of a spudger to disconnect the rear-facing camera connector.

Remove the following Phillips screws securing the rear camera bracket to the rear case:

One 1.3 mm screw

One 2.5 mm screw

Remove the bracket.

Use the pointed end of a spudger to pry up and disconnect the antenna bus connector, just left of the rear camera module.

Remove the two 1.2 mm tri-point screws securing the upper cable bracket.

Remove the upper cable bracket.

Use the flat end of a spudger to disconnect the upper cable connector.

Remove the four Phillips screws securing the Wi-Fi antenna:

Three 1.2 mm screws

One 1.7 mm screw

Remove the top left antenna.

Remove the following Phillips screws:

One 1.3 mm screw

One 2.2 mm screw

Remove the bracket.

Remove the 2.2 mm standoff screw from the grounding bracket.

Use tweezers to gently bend the logic board grounding bracket out of the way.