Introduction
Prerequisite guide for disconnecting the battery connector.
What you need
-
-
Tool used on this step:Tri-point Y000 Screwdriver$5.99
-
Remove four tri-point Y000 screws securing the lower connector bracket, of the following lengths:
-
Three 1.2 mm screws
-
One 2.4 mm screw
Ask FixBot
-
-
-
-
Use the point of a spudger to lift the battery connector out of its socket on the logic board.
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
