Fix Your Stuff Community Store

iPhone 6 Plus Logic Board Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

Introduction

Prereq only, battery removed.

What you need

  1. iPhone 6 Plus Logic Board Replacement, Logic Board: step 1, image 1 of 1
    Tool used on this step:
    Standoff Screwdriver for iPhones
    $5.49
    Buy

    • Remove the following screws securing the logic board to the rear case:

    • Two 2.4 mm standoff screws

    • Standoff screws are best removed using a standoff screwdriver or bit.

    • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

    • One 2.1 mm Phillips #00 screw

    Edit

  2. iPhone 6 Plus Logic Board Replacement: step 2, image 1 of 1

    • Carefully raise—but do not remove—the logic board, lifting it from the bottom edge nearest the Lightning connector.

    Edit

  4. iPhone 6 Plus Logic Board Replacement: step 3, image 1 of 1

    • Do not remove the logic board. At this point it is still tethered to the rear case via an antenna connector.

    • Continue carefully lifting the bottom side of the logic board until it is vertical.

    Edit

  5. iPhone 6 Plus Logic Board Replacement: step 4, image 1 of 2 iPhone 6 Plus Logic Board Replacement: step 4, image 2 of 2

    • Gently lay the logic board upside-down, with the top portion resting against the rear case of the iPhone.

    • Use the flat end of a spudger to disconnect the antenna connector from its socket on the back of the logic board.

    Edit

  6. iPhone 6 Plus Logic Board Replacement: step 5, image 1 of 1

    • Lift and remove the logic board out of the iPhone.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 12

All Time: 583