Skip to main content

iPhone 6 Plus Lightning Connector Assembly Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. iPhone 6 Plus Lightning Connector Assembly Replacement, Lightning Connector Assembly: step 1, image 1 of 1
    • Remove the two 3.3 mm Phillips #00 screws securing the metal bracket to the Lightning connector assembly.

  2. iPhone 6 Plus Lightning Connector Assembly Replacement: step 2, image 1 of 1
    Tool used on this step:
    Tweezers
    $4.99
    Buy
    • Use a pair of tweezers to lift and remove the metal bracket out of the iPhone.

  3. iPhone 6 Plus Lightning Connector Assembly Replacement: step 3, image 1 of 1
    • Use the flat edge of a spudger to pry the antenna connector cable up off its socket on the Lightning connector assembly.

  4. iPhone 6 Plus Lightning Connector Assembly Replacement: step 4, image 1 of 1
    • Lift and remove the antenna connector out of the iPhone.

  5. iPhone 6 Plus Lightning Connector Assembly Replacement: step 5, image 1 of 1
    • Remove the following Phillips #00 screws securing the Lightning connector assembly to the rear case:

    • Two 3.2 mm screws

    • One 3.8 mm screw

    • Two 1.7 mm screws

    • Two 1.5 mm screws

    • Two 1.4 mm screws

    There were 3x1.4 and a single 1.5 that was in the top right, which makes sense in regards to the frame location.

    Crav - Reply

    I don't have the 3.8mm for that spot. Just double checking on of that's the correct size

    Sare - Reply

  6. iPhone 6 Plus Lightning Connector Assembly Replacement: step 6, image 1 of 1
    • Use a pair of tweezers to grasp the plastic clip that is situated to the right of the headphone jack and remove it from the iPhone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 11

All Time: 1,823