Lower Cable Shield
Chayton Ritter and
Last updated on Jul 10, 2026
Views: 183
View statistics:
- Past 24 Hours:
- 0
- Past 7 Days:
- 3
- Past 30 Days:
- 11
- All Time:
- 183
Comments: 3
3 comments on steps.
Completed: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Prerequisite Only
This is a prerequisite-only guide! This guide is part of another procedure and isn’t meant to be used alone.
Introduction
Go to step 1 ↓This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.
What you need
Tools
-
-
-
-
Spudger4.9
-
-
-
-
-
Use a Phillips screwdriver to remove the five screws securing the lower cable shield to the logic board:
-
Two 2.0 mm screws
-
Three 1.3 mm screws
Ask FixBot
-
-
-
Tool used on this step:Tweezers$4.99
-
Use tweezers or your fingers to grab and remove the lower cable shield.
-
-
To reassemble your device, follow these instructions in reverse order.
