iPad Pro Thermal Paste Replacement
Chayton Ritter and 2 other contributors
Last updated on May 7, 2024
Views: 3.7K
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 33
- Past 30 Days:
- 152
- All Time:
- 3,723
Comments: 1
1 guide comment.
Go to guide commentsCompleted: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓Follow this guide to replace the thermal paste in your iPad Pro.
This guide applies to iPad models with a copper tape logic board shield.
The processor in your iPad Pro might be small, but it can generate a lot of heat. Thermal paste helps transfer the heat away from the processor, so it can be dissipated elsewhere.
If you removed the logic board shield from your iPad Pro, you'll need to replace the thermal paste. Your iPad Pro will work without thermal paste. However, it will overheat and may slow down to keep itself cool. Reusing thermal paste is better than nothing, but should only be done if you don't have access to new thermal paste.
Apply new thermal paste to keep your iPad Pro working safely and at full capacity.
What you need
-
-
-
Use a spudger to scrape away the old thermal paste from the processor.
-
Use a cotton swab or lint-free cloth with high-strength (>90%) isopropyl alcohol to clean any remaining thermal paste.
Ask FixBot
-
-
-
Repeat the previous step for the logic board shield.
-
-
-
Apply a rice grain-sized amount of thermal paste to the middle of the processor.
-
-
Tool used on this step:Tesa 61395 Tape$8.95
-
Apply Tesa tape along the edges of the logic board shield.
-
-
-
Tool used on this step:Tweezers$4.99
-
Use tweezers or your fingers to remove the protective paper lining from the Tesa tape.
-
Align the shield over the logic board in the correct orientation.
-
Lay the shield over the logic board.
-
-
-
Slide your finger along the perimeter of the shield to secure it to the logic board.
-
-
For more iPad Pro guides, click here.
Cancel: I did not complete this guide.
One other person completed this guide.
