Tools Featured in this Teardown

Introduction

This is the teardown for a Clamcase for iPad 2.

This teardown is not a repair guide. To repair your iPad ClamCase, use our service manual.

You can skip the first 2 steps if you don't want to detach the upper and keyboard covers from each other.
  • You can skip the first 2 steps if you don't want to detach the upper and keyboard covers from each other.

  • Open the case and unpeel the 2 black stickers in the top corners of the keyboard.

  • This will reveal the 6 screws that attach the upper cover to the keyboard cover.

Add Comment

Use the T9 Torx screwdriver to unscrew the 2 bigger screws in the middle of each side.
  • Use the T9 Torx screwdriver to unscrew the 2 bigger screws in the middle of each side.

  • Use the T6 Torx screwdriver to unscrew the remaining 4 screws.

Add Comment

  • Turn the keyboard cover over so the bottom is facing up. Manually remove the thin black covering that is attached to the bottom.

  • Be patient, the thin black covering might be really stuck to the bottom.

Add Comment

  • Once the thin black covering is removed, you will see 15 screws.

  • Use the T6 Torx screwdriver to remove the screws.

Add Comment

  • Once the screws are removed, lift off the bottom panel to access the keyboard and battery.

Add Comment

  • You are done.

Add Comment

Izmet Barranco

Member since: 12/12/2012

213 Reputation

1 Guide authored

2 Comments

Awesome! I used this guide to disassemble my clam case and repair some nonfunctional keys. Thanks!

justin duff - Reply

Thanks for the dis-assembly guide. Justin, what did you have to do to fix the keys that were not working. I have on with a few keys not working, not even intermittently.

dick haynes - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 38

All Time: 6,254