Introduction

Moving LCD out of the way to remove random internal components. Internal Prerequisite.

Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.
  • Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.

It would be good to see how reassembling.

Gabriel Ganga - Reply

Yes, or at least show where the adhesive parts go

Luke Barone - Reply

I'll second the request to see how to reassemble!

Maggie - Reply

New Battery = Faster iPhone
Fix Kits starting at $16.99
The front panel ribbon cables are connected beneath the LCD. To access them, you'll need to temporarily flip the LCD over and out of the way. Be very careful when moving the LCD, and do not attempt to remove it from the iPad—its display data cable will remain connected while it is rotated over.
  • The front panel ribbon cables are connected beneath the LCD. To access them, you'll need to temporarily flip the LCD over and out of the way.

    • Be very careful when moving the LCD, and do not attempt to remove it from the iPad—its display data cable will remain connected while it is rotated over.

  • Lift the LCD from its long edge closest to the volume buttons and gently flip it out of the rear case—like turning the page in a book.

  • Set the LCD face down on the front panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 410