iNet M1001 Motherboard Replacement
Abdulateef Abola and 2 other contributors
Last updated on May 26, 2017
Views: 731
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 21
- Past 30 Days:
- 72
- All Time:
- 731
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Introduction
Go to step 1 ↓This guide will show users how to replace the motherboard of the iNet M1001 tablet. This guide is for you if one or more parts of your motherboard have gone out. For example if the WiFi chip, gyroscope, or board has gone bad. This guide uses soldering in a few steps to get the board out.
What you need
Tools
-
-
-
Press the small suction cup on the back cover, and then pull the small suction cup to remove the back cover.
-
-
-
-
Desolder the black and red wires and pull them off of the motherboard.
-
Check out this awesome guide for tips on soldering and desoldering.
-
-
-
Push out the ribbon cable connectors with a tweezer and pull out the ribbon cable.
-
-
-
Lift up the zero insertion force clip with a tweezer and pull out the ribbon cable.
-
-
-
-
Lift up the zero insertion force clip with a plastic opening tool and pull out the ribbon cable.
-
-
-
Remove the five 5.7mm PH00 screws with a screwdriver and pull out the motherboard.
-
-
Ask FixBot
To reassemble your device, follow these instructions in reverse order.
Team
IUPUI, Team 4-1, Baechle Spring 2017 Member of IUPUI, Team 4-1, Baechle Spring 2017
IUPUI-BAECHLE-S17S4G1
2 Members
48 Guides authored
