Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Introduction

Prereq only.

Parts

No parts specified.

  1. Lift the hard drive from the edge nearest the logic board and pull it slightly out of its recess. The hard drive is attached by a single SATA power/data cable, do not attempt to fully remove it from the iMac. The hard drive is attached by a single SATA power/data cable, do not attempt to fully remove it from the iMac.
    • Lift the hard drive from the edge nearest the logic board and pull it slightly out of its recess.

    • The hard drive is attached by a single SATA power/data cable, do not attempt to fully remove it from the iMac.

  2. Use a spudger to disconnect the single SATA power and data combo cable. Use a spudger to disconnect the single SATA power and data combo cable. Use a spudger to disconnect the single SATA power and data combo cable.
    • Use a spudger to disconnect the single SATA power and data combo cable.

  3. Remove the hard drive from the iMac.
    • Remove the hard drive from the iMac.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 46