Introduction

Remove the access door to replace RAM chips.

Parts

No parts required.

Image 1/1: Remove the two Phillips screws securing the access door to the bottom grille of your iMac.
  • Orient the iMac face-side down on a table with the bottom edge facing yourself.

  • Remove the two Phillips screws securing the access door to the bottom grille of your iMac.

  • The screws are captive in the access door.

  • Before beginning the repair, unplug the computer and press and hold the power switch for 20-30 seconds, to discharge internal capacitors.

As you remove the screws during these steps, place them on a towel or a piece of cardboard. With a Sharpie label a piece of masking tape with the step number from which they were taken from. Then place the removed screws under the tape.

This ongoing step will aid in you having control on your reassembly without searching for and identifying the size and length all the screws that you are about to remove.

R51801 - Reply

Image 1/1:
  • Remove the access door.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

14 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 28

All Time: 9,806