Introduction

You will be replacing the AC power connector and cord in the device to make sure you will have power to the device.

Image 1/2: Image 2/2:
  • Make sure you remove all seven 3 mm screws before proceeding to the next step.

Add Comment

Image 1/2: Image 2/2:
  • Use iOpener or heat gun on all sides except the front.

Add Comment

Image 1/2: The top of the device will be very difficult to remove because of the adhesive holding it together. Image 2/2: The top of the device will be very difficult to remove because of the adhesive holding it together.
  • Be cautious when taking the top of the device off there may still be some adhesive stuck to device.

  • The top of the device will be very difficult to remove because of the adhesive holding it together.

Add Comment

Image 1/1:
  • Remove the one (13.5mm in length) srew holding the power connector and cord in place.

Add Comment

Image 1/1:
  • Remove the power cord connected to the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Allen Dover

Member since: 03/21/2017

401 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 51