Introduction

Use this guide to remove your iHome iP1's dock cover. This cover is located on the underside of the iPod/iPhone dock. Although it serves no function other than to protect the command button and dock assemblies, it is necessary to remove in order to access other components of the iHome iP1, such as the 30-pin connector and the command buttons.

Parts

No parts required.

Orient the iHome upside down with the speakers facing you.
  • Orient the iHome upside down with the speakers facing you.

Add Comment

Remove the two 9.5 mm Phillips #1 screws from the dock cover.
  • Remove the two 9.5 mm Phillips #1 screws from the dock cover.

Add Comment

Remove the dock cover by grabbing its sides and pulling it up and away from the faceplate. Remove the dock cover by grabbing its sides and pulling it up and away from the faceplate. Remove the dock cover by grabbing its sides and pulling it up and away from the faceplate.
  • Remove the dock cover by grabbing its sides and pulling it up and away from the faceplate.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Wen Sullivan

Member since: 10/06/2016

464 Reputation

4 Guides authored

Team

Cal Poly, Team 20-1, Livingston Fall 2016 Member of Cal Poly, Team 20-1, Livingston Fall 2016

CPSU-LIVINGSTON-F16S20G1

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 39