Introduction
This guide will help the user replace the individual light fixtures inside this device. You will need a screwdriver and a metal spudge.
What you need
-
-
-
On the opposite side of the speaker should be a sticker, remove it with your fingers or the flat plastic iFIxit tool.
-
Use a Philip's screwdriver to take the screws out of the cover.
Ask FixBot
-
-
-
Once the screws are all out, the cover should come off revealing the motherboard.
-
-
-
You will notice that the triangular black volume piece is loose, make sure to take that off revealing the buttons.
-
Once that is done, the motherboard can be taken out. May require some wiggling.
-
Make sure none of the wires are damaged and that they are all connected.
-
-
-
-
The connections shown here can be taken off by pulling on the white plastic connector piece.
-
The same can be said about the white, paper like, connectors. Pull on them gently.
-
Once all connections are apart, the motherboard is safe to be replaced.
-
-
-
-
-
Use the screwdriver to unscrew the screws on the left and right sides.
-
-
-
Lift the base of the light fixture out with the lights.
-
Be careful. The light fixture's can be easily bent.
-
-
-
Pull gently on the individual light fixture that needs to be replaced.
-
Place new individual LED light strip.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
University of North Texas, Team S1-G3, Thompson Fall 2017 Member of University of North Texas, Team S1-G3, Thompson Fall 2017
UNT-THOMPSON-F17S1G3
4 Members
4 Guides authored
