Introduction

This guide will show how to install a new mother board in the iHome. For help troubleshooting click the link to our troubleshooting page iHome IH11 Troubleshooting.

Unscrew the two 9.0 mm screws with a Phillips #1 screwdriver.
  • Unscrew the two 9.0 mm screws with a Phillips #1 screwdriver.

  • Remove the translucent bottom case.

Add Comment

Remove the two Phillips #1 9.0mm screws on the back of the iHome. Repeat the previous step for the two 9.0mm screws on the bottom.
  • Remove the two Phillips #1 9.0mm screws on the back of the iHome.

  • Repeat the previous step for the two 9.0mm screws on the bottom.

  • Carefully slide the back cover off. There are wires connected to the back cover.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the aluminum bracket by loosening the two nuts and removing the 8.0 mm bolts.
  • Remove the aluminum bracket by loosening the two nuts and removing the 8.0 mm bolts.

  • Pull the bracket out.

Add Comment

Remove the two 12.0mm screws that hold the motherboard with a Phillips #1 screwdriver. Slide the motherboard gently out.
  • Remove the two 12.0mm screws that hold the motherboard with a Phillips #1 screwdriver.

  • Slide the motherboard gently out.

Add Comment

Solder each wire to corresponding input on the motherboard.
  • Solder each wire to corresponding input on the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Courtney Steinberg

Member since: 04/19/2013

23 Reputation

3 Guides authored

Team

Cal Poly, Team 14-9, Maness Spring 2013 Member of Cal Poly, Team 14-9, Maness Spring 2013

CPSU-MANESS-S13S14G9

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 8

All Time: 219