Introduction

This guide will show you how to replace the battery on the iHealth Edge. You must take the device and remove the two piece that are stuck together using a blow dryer. This will expose the inside of the device to see screen. This is where we will begin to learn how to replace the battery.

Lightly heat device with hair dryer for 15 seconds to  soften adhesive.
  • Lightly heat device with hair dryer for 15 seconds to soften adhesive.

Add Comment

After heating adhesive, firmly pry apart the two halves.
  • After heating adhesive, firmly pry apart the two halves.

Add Comment

Remove polymer cover that is protecting the mother board, it should just come out when two halves are separated.
  • Remove polymer cover that is protecting the mother board, it should just come out when two halves are separated.

Add Comment

Use a spudger or plastic opening tool to assist the removal of the motherboard. Pry up on  two tabs and the mother board will pop out.
  • Use a spudger or plastic opening tool to assist the removal of the motherboard. Pry up on two tabs and the mother board will pop out.

Add Comment

This shows the mother board and battery out and exposed.
  • This shows the mother board and battery out and exposed.

Add Comment

You must remove the solder from two wires from the motherboard that are connected to the battery.
  • You must remove the solder from two wires from the motherboard that are connected to the battery.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Gabrielle Bettegnies

Member since: 08/23/2017

301 Reputation

3 Guides authored

Team

IUPUI, Team S1-G4, Freund Fall 2017 Member of IUPUI, Team S1-G4, Freund Fall 2017

IUPUI-FREUND-F17S1G4

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 18

All Time: 114