Image 1/1: Lift the battery out of the computer.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

Add Comment

Image 1/1:
  • Use a pin to remove the three rubber feet from the lower case.

Add Comment

Image 1/1:
  • Remove the three newly-revealed Phillips screws.

Add Comment

Image 1/1:
  • Use a spudger or small flathead screwdriver to pry up the three metal rings that housed the rubber bumpers.

Add Comment

Image 1/1: The screw in the center is shorter than the other two.
  • Remove the three hex screws using a T8 Torx screwdriver.

  • The screw in the center is shorter than the other two.

Add Comment

Image 1/1:
  • Remove the two Phillips screws on either side of the battery contacts.

Add Comment

Image 1/1: Push the thin rims of the lower case surrounding the battery compartment in, bending them past the tabs, and then lift up to free that corner of the lower case.
  • Breathe deeply. Trying times are ahead, but we promise the lower case does come off.

  • Push the thin rims of the lower case surrounding the battery compartment in, bending them past the tabs, and then lift up to free that corner of the lower case.

Add Comment

Image 1/1: Use a small flathead screwdriver to pry out the slot's lower rim and pull up on the lower case to free the slot from the tabs holding it.
  • There is a slot on the wall of the battery compartment that locks the lower case in place.

  • Use a small flathead screwdriver to pry out the slot's lower rim and pull up on the lower case to free the slot from the tabs holding it.

Add Comment

Image 1/1: Pull up on the lower case and continue to use the spudger as necessary until you hear three distinct clicks.
  • Run a spudger along the seam between the lower case and upper case on the front of the computer to free the tabs locking the lower case.

  • Pull up on the lower case and continue to use the spudger as necessary until you hear three distinct clicks.

Add Comment

Image 1/1: There are two tabs on the port side of the computer, one near the front corner and one near the sound out port.
  • Continue to run the spudger around the front, right corner.

  • There are two tabs on the port side of the computer, one near the front corner and one near the sound out port.

Add Comment

Image 1/1: Pull the lower case up and toward you until the back tabs pop free.
  • Once the front and sides of the lower case are free, turn the computer so that the back is facing you.

  • Pull the lower case up and toward you until the back tabs pop free.

  • It may be helpful to jiggle the case up and down.

Add Comment

Image 1/1:
  • Remove the small greasy springs with white plastic caps from either side of the battery contacts.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

716 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 4,064