To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver. The location of the other two screws are marked in red.
  • To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.

  • The location of the other two screws are marked in red.

Add Comment

After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
  • After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.

Add Comment

Desolder the yellow and black wires that connect the solar panel to the circuit board. Remove the solar panel by pressing on the mounting clips (underneath fingers) using the spudger.
  • Desolder the yellow and black wires that connect the solar panel to the circuit board.

  • Remove the solar panel by pressing on the mounting clips (underneath fingers) using the spudger.

Add Comment

Solder the wires to the solar panel (positive to positive, negative to negative). Solder the wires to the solar panel (positive to positive, negative to negative).
  • Solder the wires to the solar panel (positive to positive, negative to negative).

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jeremiah Rhoades

Member since: 11/07/2017

349 Reputation

3 Guides authored

Team

IUPUI, Team S2-G3, Harley Fall 2017 Member of IUPUI, Team S2-G3, Harley Fall 2017

IUPUI-HARLEY-F17S2G3

3 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 61