anko Oscillating Fan Heater Disassembly

Step 1 anko Oscillating Fan Heater Disassembly

• Show what the package look like.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2



• Remove the seven screws on the top, four can be seen in the picture, and there are three similar screws on the opposite side.
• Note: Disassembly requires the use of a special screwdriver, as shown in the picture.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Remove the rubber cover, then loosen the two internal phillips screws to release the fan and heating wire.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Pry open the two knobs (they are plugged in), you can see two screws on each side, unscrew them to remove the gear switch and temperature switch.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5
• Unscrew these two screws to separate the upper and lower parts.
• Pallets require special tools to separate.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 6
• As shown at the bottom, just unscrew all the phillips screws.
• Note: All terminals can be pulled out only by pressing the part shown in Figure 2 with a small or a tool, and should not use brute force.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 7
• The complete disassembly is shown
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Special thanks to these translators:

zh en

100%

Tom YAN

Tom YAN is helping us fix the world! Want to contribute?
Start translating ›

Author

with 1 other contributor

Tom YAN

Member since: 10/23/23

217 Reputation

1 Guide authored

Badges: 3

• 
• 
• 

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview