Introduction

This guide shows how to safely separate the main circuit board from the remainder of Zoomer Dino Boomer so that it can be replaced without damage to the electrical system.

Power off Zoomer Dino Boomer before disassembly.
  • Power off Zoomer Dino Boomer before disassembly.

  • Remove the eight 9.3mm Phillips #1 screws.

Add Comment

Turn dinosaur over and hold upright. Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.
  • Turn dinosaur over and hold upright.

  • Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.

  • Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.

Add Comment

Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers. Remove back cover. If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.
  • Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.

  • Remove back cover.

  • If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.

  • Do not damage the wires or circuit board.

Add Comment

Use tweezers to remove all of the colored wire connectors from their sockets on the circuit board. Use tweezers to remove all of the colored wire connectors from their sockets on the circuit board. Use tweezers to remove all of the colored wire connectors from their sockets on the circuit board.
  • Use tweezers to remove all of the colored wire connectors from their sockets on the circuit board.

Where can i find the circuit board to purchase?

Scott G - Reply

Remove legs. Remove legs.
  • Remove legs.

Add Comment

Remove the  three 7.2 mm Phillips #0 screws connecting the main circuit board to the body of Zoomer Dino Boomer.
  • Remove the three 7.2 mm Phillips #0 screws connecting the main circuit board to the body of Zoomer Dino Boomer.

Add Comment

Use soldering iron and tweezers  to disconnect main circuit board from the black and red wires. Check out iFixit's soldering techniques guide to learn more about soldering and desoldering connections. Remove main circuit board from Zoomer Dino Boomer
  • Use soldering iron and tweezers to disconnect main circuit board from the black and red wires.

  • Check out iFixit's soldering techniques guide to learn more about soldering and desoldering connections.

  • Remove main circuit board from Zoomer Dino Boomer

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Desiree DesJardins

Member since: 09/02/2015

410 Reputation

2 Guides authored

Team

USF Tampa, Team 16-1, Wollert Fall 2015 Member of USF Tampa, Team 16-1, Wollert Fall 2015

USFT-WOLLERT-F15S16G1

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 16

Past 30 Days: 81

All Time: 1,681