Introduction

Everyone likes to listen to music right? Then we need to learn how to get to the headphone jack if it needs to be fixed.

Image 1/2: Image 2/2:
  • Pull off back cover at bottom right corner.

Add Comment

Image 1/2: Image 2/2:
  • Remove the seven 3.175mm Phillips head screws from the inner back located at the top, upper-middle-right, middle-right, lower-right, and bottom.

Add Comment

Image 1/2: Be careful not to pry it off too hard, as it is just a plastic covering. Image 2/2: Be careful not to pry it off too hard, as it is just a plastic covering.
  • With the plastic opening tool the spudger, gently pry off the inner back.

  • Be careful not to pry it off too hard, as it is just a plastic covering.

Add Comment

Image 1/1:
  • Remove the one 2.381mm Phillips head screw from the motherboard located in the upper-middle part of the phone next to the bottom left corner of the back camera.

Add Comment

Image 1/3: ZIF connectors have a tiny tab that needs to be flipped up  in order to safely remove the cable Image 2/3: Using same spudger, gently pry up the orange flat top connector Image 3/3: Using same spudger, gently pry up the orange flat top connector
  • Using the spudger, gently pry up all ZIF connectors

  • ZIF connectors have a tiny tab that needs to be flipped up in order to safely remove the cable

  • Using same spudger, gently pry up the orange flat top connector

Add Comment

Image 1/2: Image 2/2:
  • Carefully take off motherboard.

Add Comment

Image 1/2: Image 2/2:
  • Flip over motherboard to locate headphone jack circuit.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Garrett Barry

Member since: 03/04/2016

623 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 127