Introduction

Removing the cameras of the ZTE Speed is a very simple process, proceed below!

Image 1/2: Image 2/2:
  • Pull off back cover at bottom right corner.

Add Comment

Image 1/2: Image 2/2:
  • Remove the seven 3.175mm Phillips head screws from the inner back located at the top, upper-middle-right, middle-right, lower-right, and bottom.

Add Comment

Image 1/2: Be careful not to pry it off too harsh, as it is just plastic. Image 2/2: Be careful not to pry it off too harsh, as it is just plastic.
  • With the plastic opening tool the spudger, gently pry off the inner back seal around the phone.

  • Be careful not to pry it off too harsh, as it is just plastic.

Add Comment

Image 1/2: With the spudger, gently pry off camera at the top-left of the phone to get the front camera. Image 2/2: With the spudger, gently pry off camera at the top-left of the phone to get the front camera.
  • With the spudger, gently pry off camera at the top-middle of the phone to get back camera.

  • With the spudger, gently pry off camera at the top-left of the phone to get the front camera.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Garrett Barry

Member since: 03/04/2016

623 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 7

All Time: 187