What you need
-
-
-
Remove the seven 12mm JIS #00 screws that hold the back panel in place.
Ask FixBot
-
-
-
Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
-
-
-
-
-
-
Remove the electrical connector attaching each rumble motor to the controller.
-
Lift up on the circular section of the rumble to remove it from the controller.
-
-
-
-
-
Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Grand Valley State University, Team S4-G1, DeVasto Fall 2019 Member of Grand Valley State University, Team S4-G1, DeVasto Fall 2019
GVSU-DEVASTO-F19S4G1
4 Members
84 Guides authored
