Introduction
This simple guide describes the process of removing the battery from the Yuneec ST16S controller, either for recharging or replacement. The ST16S uses a rechargeable lithium ion 3.6 volt battery. To tell if your battery needs to be replaced, visit this troubleshooting guide.
-
-
Hold down the button located above the battery while applying downward pressure to the battery.
-
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
UMass Dartmouth, Team 4-2, Gulbrandsen Fall 2021 Member of UMass Dartmouth, Team 4-2, Gulbrandsen Fall 2021
UMASSD-GULBRANDSEN-F21S4G2
3 Members
6 Guides authored
