Fix Your Stuff Community Store

Yuneec ST10 Plus Battery Replacement

Introduction

If you own a Yuneec ST10 Plus, there is a chance your battery will stop holding its charging capacity over time. The main causes of this issue are battery overheating, and the end of your battery charge/discharge cycles. Follow this step-by-step guide on how to replace your battery. No tools required and a quick replacement.

  1. Yuneec ST10 Plus Battery Replacement, Battery: step 1, image 1 of 1

    • Flip the controller upside down to access the battery compartment.

    • Grab the compartment door and pull down.

    Edit

  3. Yuneec ST10 Plus Battery Replacement: step 2, image 1 of 1

    • Gently lift the blue tab connected to the battery in order to remove the battery from its housing.

    Edit

  4. Yuneec ST10 Plus Battery Replacement: step 3, image 1 of 3 Yuneec ST10 Plus Battery Replacement: step 3, image 2 of 3 Yuneec ST10 Plus Battery Replacement: step 3, image 3 of 3

    • To disconnect the battery from the remote, grab the red and black connectors.

    • Pull gently on connectors until they disconnect.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 143