Introduction

This guide will show you how to open the XtremeMac Luna so that its inner components are easily accessible.

Parts

No parts required.

Image 1/3: Remove the battery lid by pressing the battery cover's tab and pulling it away from the device. Image 2/3: Push the battery against the spring and lift it out of the casing. Image 3/3: Repeat with the other battery.
  • Flip the device over so that the batteries are closest to you.

  • Remove the battery lid by pressing the battery cover's tab and pulling it away from the device.

  • Push the battery against the spring and lift it out of the casing.

  • Repeat with the other battery.

Add Comment

Image 1/1: The iFixit 26 bit screwdriver kit will not reach the screws.  Make sure to use a screwdriver that is thin enough to not get stuck in the screw holes.
  • Unscrew all eight 12mm Phillips head screws with a Philips #1 screwdriver.

  • The iFixit 26 bit screwdriver kit will not reach the screws. Make sure to use a screwdriver that is thin enough to not get stuck in the screw holes.

Add Comment

Image 1/2: Gently tilt the lid back 45 degrees so that the inside is exposed. Image 2/2: Be mindful of the wires inside of the Luna. It is easy to break a connection if a wire gets caught.
  • Flip the Luna back over so that the buttons are facing upward and the LCD screen is facing you.

  • Gently tilt the lid back 45 degrees so that the inside is exposed.

  • Be mindful of the wires inside of the Luna. It is easy to break a connection if a wire gets caught.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Johnson

Member since: 04/14/2013

1 Reputation

1 Guide authored

Team

Cal Poly, Team 3-47, Amido Spring 2013 Member of Cal Poly, Team 3-47, Amido Spring 2013

CPSU-AMIDO-S13S3G47

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 226