What you need
-
-
Locate the two screws on the back of the car towards the front. Use a #J0 JIS screw to loosen the screws.
Ask FixBot
-
-
-
-
Remove the back-cover off and make sure there are no rust or disconnected wires.
-
-
-
Locate the receiver which is towards the back end of the car.
-
Replace the receiver by disconnecting the wires.
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Appalachian State University, Team S1-G2, Menagarishvili Fall 2018 Member of Appalachian State University, Team S1-G2, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S1G2
2 Members
6 Guides authored
