You can remove the side panels with a pry tool. You don't need to remove the rubber.  The rubber on this controller was already bad
  • You can remove the side panels with a pry tool.

  • You don't need to remove the rubber. The rubber on this controller was already bad

Add Comment

Remove the 5 Torx Security Bit (TR8) screws
  • Remove the 5 Torx Security Bit (TR8) screws

all the T8 screws on my controller have a clear filling in them, WTF?!?!?

Patrick Henry - Reply

all my T8 screws have a clear filling in them, WTF?!?!?!

Patrick Henry - Reply

I've never seen that, I can't advise much other than scrapping it out with an xacto knife

EasyAsABC123 - Reply

My screws have a tiny metal pin in the center. Looks like I need a TR8 bit, not a T8. This might be what you are mistaking for a clear filling.

Steve McGinn - Reply

Thanks it might be TR8 i’ll update the guide

EasyAsABC123 - Reply

Pry the panel next to the 3.5mm port Be careful to not rip the ribbon shown in the next step Be careful to not rip the ribbon shown in the next step
  • Pry the panel next to the 3.5mm port

  • Be careful to not rip the ribbon shown in the next step

Add Comment

Be careful to not rip the ribbon cable You can pop the connector up to remove the ribbon easily
  • Be careful to not rip the ribbon cable

  • You can pop the connector up to remove the ribbon easily

  • Ribbon Cable

Add Comment

Remove the 2 Torx (T6) screws
  • Remove the 2 Torx (T6) screws

Add Comment

Desolder the 4 wires on each side, these control the vibrations and the RT LT Desolder the 4 wires on each side, these control the vibrations and the RT LT
  • Desolder the 4 wires on each side, these control the vibrations and the RT LT

Add Comment

Pull up from the "top" side of the controller on the sister board. Pull up from the "top" side of the controller on the sister board.
  • Pull up from the "top" side of the controller on the sister board.

Hi,

I would like to know if I could get from you a Motherboard . In case you don' t have it, where could I find one?

Thank you

Alejandro Expósito - Reply

Be Careful to not lose the sync button Pry the middle section up from the home button side. This will also remove the LB and RB which is a single part
  • Be Careful to not lose the sync button

  • Pry the middle section up from the home button side.

  • This will also remove the LB and RB which is a single part

Add Comment

Unscrew the 6 Torx (T6) screws Unscrew the 6 Torx (T6) screws
  • Unscrew the 6 Torx (T6) screws

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

EasyAsABC123

Member since: 01/22/2010

1,104 Reputation

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 9

Past 7 Days: 28

Past 30 Days: 100

All Time: 1,823