Introduction

The remote control motherboard plays a major part in the connection between the remote control and the car. This guide steps you through replacing it.

Turn off the remote control. Flip power switch to the off position.
  • Turn off the remote control. Flip power switch to the off position.

  • Remove the battery from bottom of remote control for further safety measures.

Add Comment

The following steps require using a three inch  #1 Phillips head screwdriver.
  • The following steps require using a three inch #1 Phillips head screwdriver.

  • Remove all seven 3mm Phillips #2 screws from the underside panel.

Add Comment

  • Remove five 3mm Phillips #2 screws that connect the motherboard to the back outer shell.

Add Comment

  • Detach the motherboard. Use soldering tools to desolder off the red and black wires from the motherboard. To do this, refer to the how to solder/desolder page.

Add Comment

  • Replace the motherboard. Solder the wires back on to the new motherboard using the soldering kit. The black wire should be on the left and the red wire should be on the right.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cate Kraska

Member since: 04/01/2015

126 Reputation

1 Guide authored

Team

Cal Poly, Team 12-6, Lancaster Spring 2015 Member of Cal Poly, Team 12-6, Lancaster Spring 2015

CPSU-LANCASTER-S15S12G6

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 339