Wire Stripping
nat coll and 9 other contributors
Last updated on Oct 15, 2024
Views: 14K
View statistics:
- Past 24 Hours:
- 6
- Past 7 Days:
- 78
- Past 30 Days:
- 442
- All Time:
- 14,373
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 24 25
24 people have marked this guide "completed." Will you be next?
25 people have marked this guide "completed." Including you — great job!
Favorites: 8 9
8 people have favorited (and subscribed to) this guide. Will you be next?
9 people have favorited (and subscribed to) this guide — including you!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Introduction
Go to step 1 ↓Wire needs to be exposed from its insulation in order before it can be soldered to another wire. Wire stripping exposes the wire so you are able to make good connections.
What you need
Tools
-
-
-
-
Place the wire stripper about a 1/4” from the end of the wire and squeeze down.
-
-
-
While squeezing, pull the stripper toward the end of the wire. This should expose some of the wire by removing its insulation.
-
Ask FixBot
After your wire has been stripped, the exposed wire is ready to be soldered and reconnected to other parts of the microphone.
Cancel: I did not complete this guide.
24 other people completed this guide.
Team
Cal Poly, Team 7-53, Forte Fall 2012 Member of Cal Poly, Team 7-53, Forte Fall 2012
CPSU-FORTE-F12S7G53
5 Members
180 Guides authored
