Parts

No parts required.

Introduction

The hot plate is held in place by multiple screws along the burner ring and electrical wires. When free from the frame, take care when removing the iron plate itself as it is fairly dense.

Image 1/1: The screws in the rubber legs of the burner do not need to be removed.
  • Remove the screws on the back panel with the #1 Phillips screwdriver bit.

    • The screws in the rubber legs of the burner do not need to be removed.

    • If the back panel has never been opened before, the screws may be more difficult to unscrew.

Add Comment

Image 1/2: Image 2/2:
  • Using a wrench, remove the bolt from the center of the back panel.

Add Comment

Image 1/1:
  • The back panel can now be easily lifted off.

Add Comment

Image 1/2: The interior edges of the metal frame are sharp and can cause minor cuts. Image 2/2: 3 screws on the perimeter of the circle
  • Remove screws #1 Phillips screwdriver bit.

    • The interior edges of the metal frame are sharp and can cause minor cuts.

    • 3 screws on the perimeter of the circle

    • 1 screw in the circle

    • 2 screws on the eletrical stands with wires

Add Comment

Image 1/2: Image 2/2:
  • Remove rod from the center of the plate with a wrench.

Add Comment

Image 1/2: Image 2/2:
  • Remove plate carefully as to not damage internal components i.e. insulator, metal frame, wires, etc.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sun Fai Lau

Member since: 09/22/2014

504 Reputation

5 Guides authored

Team

USF Tampa, Team 10-7, Brown Fall 2014 Member of USF Tampa, Team 10-7, Brown Fall 2014

USFT-BROWN-F14S10G7

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 18

Past 30 Days: 123

All Time: 634