Introduction

The Wahl Chrome Pro components are protected by an outer plastic body held together by several screws. This guide provides information on how to remove the outer protective case to access various internal components.

Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
  • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

  • Make sure your device is not connected to power before you begin.

Add Comment

Lift the bottom blade straight up from the device body to remove it.
  • Lift the bottom blade straight up from the device body to remove it.

Add Comment

Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.
  • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

Add Comment

Lift the base of blade assembly straight up off of the body.
  • Lift the base of blade assembly straight up off of the body.

Add Comment

Remove the two 12.0 mm JIS #1 screws on the back of the device body.
  • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

Add Comment

Remove the 13.0 mm Phillips #2 screw on the side of the device body.
  • Remove the 13.0 mm Phillips #2 screw on the side of the device body.

    • This screw is located on the opposite side of the body from the switch.

Add Comment

Remove the spring  on the side of the body using tweezers.
  • Remove the spring on the side of the body using tweezers.

Add Comment

Pry the body case off of the device using a spudger.
  • Pry the body case off of the device using a spudger.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ashley Dale

Member since: 11/09/2017

201 Reputation

2 Guides authored

Team

IUPUI, Team S7-G3, Baechle Fall 2017 Member of IUPUI, Team S7-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G3

3 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 8

All Time: 92