1. Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
    • Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.

    Add Comment

  2. After screws have been removed, open fan up. Inside remove the black and silver directional fins.
    • After screws have been removed, open fan up. Inside remove the black and silver directional fins.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the black 5mm screw inside of the fan blade cylinder.

    Add Comment

    • Find and locate the 10 mm screws on both sides of the circuit board enclosure. Remove both screws.

    Add Comment

    • Take out the fan cylinder and the circuit board enclosure.

    Add Comment

    • Look inside the frontal shell of the fan and locate power button.

    • Remove by gently pulling button off notch and replace with new power button.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Kyle Devoe

Member since: 09/28/2017

104 Reputation

1 Guide authored

Team

USF Tampa, Team S1-G1, Nance Fall 2017 Member of USF Tampa, Team S1-G1, Nance Fall 2017

USFT-NANCE-F17S1G1

3 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 92