Installing Vinotemp VT-12TEDi Power Cord

You're viewing a previously published version of this guide. View latest version

Jul 31, 2013 - 05:09:18

Dec 04, 2015 - 03:56:36 Dec 04, 2015 - 03:56:07 Dec 04, 2015 - 03:55:43 Sep 04, 2013 - 05:36:43 Jul 31, 2013 - 05:09:18 Jul 23, 2013 - 11:28:24 Jul 22, 2013 - 10:00:16 Jul 22, 2013 - 09:54:46 Jul 22, 2013 - 09:54:35 Jul 22, 2013 - 09:52:35 Jul 22, 2013 - 09:52:10 Jul 22, 2013 - 08:18:27 Jul 22, 2013 - 08:01:09 Jul 22, 2013 - 08:01:08 Jul 22, 2013 - 07:31:42 Jul 22, 2013 - 07:31:27 Jul 22, 2013 - 07:30:35 Jul 22, 2013 - 07:29:24 Jul 22, 2013 - 07:26:51 Jul 22, 2013 - 07:25:36 Jul 22, 2013 - 07:24:13 Jul 22, 2013 - 07:19:34 Jul 22, 2013 - 07:18:44 Jul 22, 2013 - 07:13:39 Jul 22, 2013 - 07:13:28 Jul 22, 2013 - 07:09:46 Jul 22, 2013 - 07:08:40 Jul 22, 2013 - 07:07:10

Newer

What you need

Step 1 Power Cord

Installing Vinotemp VT-12TEDi Power Cord, Power Cord: step 1, image 1 of 2

Installing Vinotemp VT-12TEDi Power Cord, Power Cord: step 1, image 2 of 2

Remove nine 12mm Phillips screws from the upper back panel.
Remove three 12mm Phillips screws inset under the back panel.
As soon as the screws are removed, the panel will fall freely.
When replacing the twelve 12mm Phillips screws, do not tighten the fasteners until all twelve screws have been loosely fitted back onto the cooler. This will ensure the flimsy metal casing will not warp.

Step 2

Power Cord Fastener
Ground
Logic Board
Heat Sink Fan
Heat Sink

Step 3

Installing Vinotemp VT-12TEDi Power Cord: step 3, image 3 of 3

Remove two 7mm Hex Nuts.
Clearance is minimal and these screws are very tight. You will likely need a socket wrench to avoid stripping.
If the white plastic components stick, pry them apart with a metal spudger. Don't pull on the power cord to get plastic pieces to separate.