Fix Your Stuff Community Store

Verizon Ellipsis 10 Speaker Replacement

Introduction

This guide is designed to provide you with simple steps to remove and replace the Verizon Ellipsis 10 Speaker. This replacement will resolve any sound quality issues.

What you need

  1. Verizon Ellipsis 10 Speaker Replacement, Back Cover: step 1, image 1 of 1

    • Open the SD/SIM card cover to start prying off the back cover.

    Edit

  2. Verizon Ellipsis 10 Speaker Replacement: step 2, image 1 of 1

    • Start using the iFixit Opening Tool in the SD/SIM area to release the clips holding the back panel on.

    Edit

  3. Verizon Ellipsis 10 Speaker Replacement: step 3, image 1 of 1

    • Follow along the edge of the device to undo all of the retaining clips.

    Edit

  4. Verizon Ellipsis 10 Speaker Replacement: step 4, image 1 of 1

    • Once all the clips are undone, the back panel should come off with little effort.

    Edit

  6. Verizon Ellipsis 10 Speaker Replacement, Battery: step 5, image 1 of 1

    • Remove the bottom piece of tape securing the battery making sure you are not peeling up anything else in the process.

    Edit

  7. Verizon Ellipsis 10 Speaker Replacement: step 6, image 1 of 1

    • Remove the top piece of tape using an iFixit opening tool.

    Edit

  8. Verizon Ellipsis 10 Speaker Replacement: step 7, image 1 of 1

    • Once you have a hold on the tape, carefully remove it making sure you aren’t damaging the battery in the process.

    Edit

  9. Verizon Ellipsis 10 Speaker Replacement: step 8, image 1 of 1

    • Unplug the battery power connector by sliding the white plastic plug down away from the board.

    Edit

  10. Verizon Ellipsis 10 Speaker Replacement: step 9, image 1 of 1

    • The battery should be free to come out of the device. Make sure not to bend or damage the battery.

    Edit

  11. Verizon Ellipsis 10 Speaker Replacement, Speaker: step 10, image 1 of 1

    • Using a Phillips #00 screwdriver, remove the four M1.5 screws from the right speaker.

    Edit

  12. Verizon Ellipsis 10 Speaker Replacement: step 11, image 1 of 1

    • Remove the black and white wires connected to the motherboard by pulling up on their connections.

    • Remove the three strips of tape.

    Edit

  13. Verizon Ellipsis 10 Speaker Replacement: step 12, image 1 of 1

    • Remove the four M1.5 screws on the left speaker.

    • Remove the speakers from the device.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 2

Past 30 Days: 6

All Time: 145