Introduction

Use this guide to reach the motherboard on your Micro Cruz T301. This guide will help you to reach the motherboard step by step.

Image 1/1:
  • Insert the plastic opening tool in the SD port. The edge point should be pointed towards the rear panel.

Add Comment

Image 1/1:
  • Insert a small opening tool between the rear panel and the tablet.

Add Comment

Image 1/1:
  • The large opening tool is not needed any more.

Add Comment

Image 1/2: Image 2/2:
  • Move the small tool opener around the rear panel to free the 12 edges.

Add Comment

Image 1/1:
  • Using PH0 Phillips Driver, remove the 4 Screws in the Metal part.

Add Comment

Image 1/1:
  • Using a plastic Spudger remove the battery connector.

Add Comment

Image 1/1:
  • Using PH0 Phillips Driver, remove the 12 Screws in the cover.

Add Comment

Image 1/1:
  • Place a metal Spudger between the tablet and the back cover.

Add Comment

Image 1/1:
  • Move the spudger around the tablet to release the clips attached to the tablet.

Add Comment

Image 1/1:
  • Use a plastic spudger to release the connection between the speakers and the motherboard as shown in the picture.

Add Comment

Image 1/1: Use a nylon spudger to remove the top plug connector from the motherboard.
  • This guide shows the use of incorrect tools. Always use ESD safe tools when dealing with delicate internal components.

  • Use a nylon spudger to remove the top plug connector from the motherboard.

Add Comment

Image 1/2: Image 2/2:
  • Use a metal spudger to remove both screen cable connectors

Add Comment

Image 1/1:
  • use openning tools to remove the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ahmed

Member since: 10/05/2016

227 Reputation

1 Guide authored

Team

USF Tampa, Team 1-6, Cagle Fall 2016 Member of USF Tampa, Team 1-6, Cagle Fall 2016

USFT-CAGLE-F16S1G6

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 38