Introduction

Follow these instructions to disassemble an upright vacuum cleaner and remove debris like hair or string that may be preventing the floor brush from spinning.

*Exact part locations and the number of screws may vary according to the device model.

Parts

No parts required.

Be sure to unplug the device from the wall outlet before disassembling.
  • Be sure to unplug the device from the wall outlet before disassembling.

  • Remove the bottom head of the vacuum cleaner by pressing the push button.

Add Comment

Carefully unscrew the 6 screws with a  Phillips screwdriver. Set aside. Carefully unscrew the 6 screws with a  Phillips screwdriver. Set aside.
  • Carefully unscrew the 6 screws with a Phillips screwdriver. Set aside.

Add Comment

Separate the top portion of the head from the bottom.
  • Separate the top portion of the head from the bottom.

    • Make sure not to pull off or damage the connected wires.

Add Comment

Deck the Halls
With tools and Fix Kits
Slip off the belt.
  • Slip off the belt.

Add Comment

Pull the brush roll from its slots. Pull the brush roll from its slots.
  • Pull the brush roll from its slots.

Add Comment

Use scissors to cut strings and other debris from the brush roll. Avoid cutting the bristles. Use scissors to cut strings and other debris from the brush roll. Avoid cutting the bristles.
  • Use scissors to cut strings and other debris from the brush roll. Avoid cutting the bristles.

Add Comment

Return the clean brush roll and re-situate  the belt to secure it in place.
  • Return the clean brush roll and re-situate the belt to secure it in place.

Add Comment

Conclusion

To reassemble your device, follow the disassembly instructions in reverse order.

Kaitlyn Sheets

Member since: 01/19/2016

117 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 4

All Time: 172