Introduction

Use this guide to remove and replace the power distribution circuit board.

Remove batteries and SD card before beginning disassembly! Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.
  • Remove batteries and SD card before beginning disassembly!

  • Locate the four plastic screw covers denoted by the markers and gently pry them up with the metal spudger.

Add Comment

Remove all four (11mm) screws with the Philips #0 screwdriver. Remove all four (11mm) screws with the Philips #0 screwdriver.
  • Remove all four (11mm) screws with the Philips #0 screwdriver.

Add Comment

Remove the two battery cartridges located on the underside of the camera. Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera. Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.
  • Remove the two battery cartridges located on the underside of the camera.

  • Once cartridges are removed, use the metal spudger to pry open the top, bottom, and both sides of the camera.

Add Comment

Beware of the two black viewfinder lens falling out as you pry open the device!
  • Beware of the two black viewfinder lens falling out as you pry open the device!

  • The device should now be open and ready for further repair and/or replacement parts.

Add Comment

Locate and remove the screws circled in the provided image with a Philips #0 screwdriver.
  • Locate and remove the screws circled in the provided image with a Philips #0 screwdriver.

Add Comment

Unsolder the connection points on the motherboard. Unsolder the connection points on the motherboard.
  • Unsolder the connection points on the motherboard.

Add Comment

Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard. Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard. Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard.
  • Unsolder the connections to the right battery terminal. Removing the terminal allows easier access to the motherboard.

Add Comment

Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard. Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard. Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard.
  • Carefully pull up on the motherboard and pink plastic underneath the motherboard. The pink plastic contains the display and is connected to the motherboard.

Add Comment

Unsolder the wires connected to the power distribution circuit board.
  • Unsolder the wires connected to the power distribution circuit board.

Add Comment

Locate and remove the two screws that hold in the power distribution circuit board using a Philips #0 screwdriver.
  • Locate and remove the two screws that hold in the power distribution circuit board using a Philips #0 screwdriver.

Add Comment

Gently pull up on power distribution circuit board and remove it from the device.
  • Gently pull up on power distribution circuit board and remove it from the device.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Justin Sanchez

Member since: 02/08/2016

431 Reputation

4 Guides authored

Team

USF Tampa, Team 6-4, Eyestone Spring 2016 Member of USF Tampa, Team 6-4, Eyestone Spring 2016

USFT-EYESTONE-S16S6G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 13

All Time: 239