Introduction

Is the sound for your device distorted, crackling or nonexistent? This guide may be a solution to fix your problem.

To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.
  • To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.

  • A coin can also be used to loosen the screw.

Add Comment

Remove the battery door.
  • Remove the battery door.

  • Take out the batteries.

Add Comment

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Remove the rear panel screws using a Phillips #2 screwdriver.
  • Remove the rear panel screws using a Phillips #2 screwdriver.

    • Two 21.6mm (Long)

    • One 9.8mm (Short)

    • Five 13.8mm (Medium)

Add Comment

Gently pull up on the rear panel. Be careful not to pull on the wire connections.
  • Gently pull up on the rear panel.

  • Be careful not to pull on the wire connections.

  • Rest the laptop open on the table.

Laptop is not playing sound after putting new batteries . Can you tell how to repair the same.

Sapna - Reply

Use a Phillips #0 screwdriver to unscrew the two 6.0 mm screws on the speaker. Use a Phillips #0 screwdriver to unscrew the two 6.0 mm screws on the speaker.
  • Use a Phillips #0 screwdriver to unscrew the two 6.0 mm screws on the speaker.

Add Comment

Remove the two 6 mm screws from the device. Remove the speaker.
  • Remove the two 6 mm screws from the device.

  • Remove the speaker.

  • Be careful not to damage the wiring.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jordan Smith

Member since: 09/03/2015

210 Reputation

2 Guides authored

Team

USF Tampa, Team 12-2, Blackwell Fall 2015 Member of USF Tampa, Team 12-2, Blackwell Fall 2015

USFT-BLACKWELL-F15S12G2

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 9

All Time: 250