Introduction

Does your device not respond when buttons are pressed? Do only a few buttons seem to function correctly? This guide will walk through the steps required to replace the buttons.

To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.
  • To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.

  • A coin can also be used to loosen the screw.

Remove the battery door.
  • Remove the battery door.

  • Take out the batteries.

Remove the rear panel screws using a Phillips #2 screwdriver.
  • Remove the rear panel screws using a Phillips #2 screwdriver.

    • Two 21.6mm (Long)

    • One 9.8mm (Short)

    • Five 13.8mm (Medium)

New Battery = Faster iPhone
Fix Kits starting at $16.99
Gently pull up on the rear panel. Be careful not to pull on the wire connections.
  • Gently pull up on the rear panel.

  • Be careful not to pull on the wire connections.

  • Rest the laptop open on the table.

Laptop is not playing sound after putting new batteries . Can you tell how to repair the same.

Sapna - Reply

Using a Phillips #0 screwdriver remove the two 6.0mm screws.
  • Using a Phillips #0 screwdriver remove the two 6.0mm screws.

Lift up on the board and set it aside. Movement of the board will be limited. Be careful not to damage the connection to the motherboard.
  • Lift up on the board and set it aside.

  • Movement of the board will be limited. Be careful not to damage the connection to the motherboard.

Remove each button and button contact.
  • Remove each button and button contact.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Christopher Kourmoulakis

Member since: 09/03/2015

373 Reputation

3 Guides authored

Team

USF Tampa, Team 12-2, Blackwell Fall 2015 Member of USF Tampa, Team 12-2, Blackwell Fall 2015

USFT-BLACKWELL-F15S12G2

4 Members

7 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 152