Introduction

In this guide you will learn how to remove the heat sink of your Toshiba Satellite U925T-S2120. If your heat sink is clogged or broken, you may need to replace it. Before beginning this guide you should have all required tools that are listed.

Image 1/2: Image 2/2:
  • Remove the 9 rubber gripper pads on the back panel of the laptop using tweezers.

Add Comment

Image 1/3: Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw. Image 2/3: Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw. Image 3/3: Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.
  • Unscrew nine 5.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.

  • Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.

Add Comment

Image 1/2: Image 2/2:
  • Take off the back panel open by sticking the plastic opening tool into the seam of the laptop, and pushing the opening tool downwards.

Add Comment

Image 1/2: Image 2/2:
  • Unscrew three 3.4 mm screws by turning a PH1 screwdriver clockwise after inserting it into each screw.

Add Comment

Image 1/1:
  • Lift and remove the heat sink by pinching it with your thumb and pointer fingers.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Honderich

Member since: 03/29/2017

331 Reputation

3 Guides authored

Team

Baylor, Team S5-G5, Williams Spring 2017 Member of Baylor, Team S5-G5, Williams Spring 2017

BU-WILLIAMS-S17S5G5

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 7

All Time: 35