Introduction
This guide will show how to remove and replace your computer's motherboard.
What you need
-
-
Flip the laptop to the bottom side.
-
Locate and slide the two battery locks to disconnect the battery.
-
Remove the battery by sliding it out away from the computer (horizontal with the casing).
-
-
-
Use a #1 Phillips head screwdriver to remove the screw on the middle right of the RAM's cover panel.
-
Then, use a the blue iFixit Opening Tool to pry the cover panel off.
-
Push on to the RAM tabs to disconnect the RAM form the device.
-
The RAM will pop off from the socket. Gently pull the RAM out of the socket.
-
-
-
Use the #1 Phillips head screwdriver to unscrew the panel.
-
Disconnect the black and white wires.
-
Push on the tabs to disconnect the Wi-Fi card.
-
Use the blue iFixit Opening Tool to pull the Wi-Fi Card out.
-
-
-
Use the #1 Phillips head screwdriver as to remove the hard drive screw.
-
Use the blue iFixit Opening Tool to pry the cover off.
-
Use the plastic flap to pull the hard drive out of its slot.
-
-
-
-
Use the #1 Phillips head screwdriver remove the Optical Drive screw.
-
Use the blue iFixit Opening Tool to pry the Optical Drive out of the slot from the side of the casing.
-
Use your hands to pull the rest of the Optical Drive out.
-
-
-
Carefully use the blue iFixit Opening Tool to pry the panel above the keyboard from the left and right side.
-
Push back the screen until it is flat with the laptop.
-
Gently remove the clips that connect the panel to the screen.
-
-
-
Use the Phillips #1 screwdriver to remove the two screws.
-
Gently pry the keyboard from the laptop using the blue iFixit opening tool.
-
Slowly lift the keyboard away from the laptop.
-
Remove the ribbon that connects to the laptop.
-
-
-
Disconnect the video cable near the left speaker slowly but firmly pulling upwards.
-
Disconnect the brown ribbon that is located directly in the middle of where the keyboard one was away from the connector.
-
Disconnect the 2-other white ribbons located near the top right half of the keyboard section pulling firmly away from the connector.
-
-
-
Unscrew all the screws labeled using a micro-screwdriver turning counterclockwise.
-
There are 3-additional screws that need to be removed through the 3-holes located in the optical drive.
-
-
-
Using a flat-edge tool begin to pry away the case apart and slowly pulling upward as there is a white ribbon that need to be removed.
-
Make sure to completely untape the largest white ribbon, and let it slide through the top half of the case as you lift it.
-
-
-
Now lift out the motherboard. Be careful not to rip any of the pieces out, just wiggle them out.
-