Introduction

The tablet battery is located inside the tablet itself and will require a Phillips head screwdriver, prying tool, and tweezers. Also, there are a few wires and screws that need to be removed that require patience and a steady hand.

Take the pry tool and pry open the backing of the tablet around all four sides and pull off back. Take the pry tool and pry open the backing of the tablet around all four sides and pull off back. Take the pry tool and pry open the backing of the tablet around all four sides and pull off back.
  • Take the pry tool and pry open the backing of the tablet around all four sides and pull off back.

Add Comment

Use a Phillips #0 Screwdriver to remove four screws in the corners of the battery pack. Use a Phillips #0 Screwdriver to remove four screws in the corners of the battery pack.
  • Use a Phillips #0 Screwdriver to remove four screws in the corners of the battery pack.

Add Comment

Remove shown wires from clips on the left hand side of the battery before pulling the battery completely out.
  • Remove shown wires from clips on the left hand side of the battery before pulling the battery completely out.

Add Comment

Remove highlighted plug out of the circuit board before completely removing the battery pack.
  • Remove highlighted plug out of the circuit board before completely removing the battery pack.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Anthony

Member since: 01/28/2015

107 Reputation

1 Guide authored

Team

Penn State, Team 2-20, Kaschak Winter 2015 Member of Penn State, Team 2-20, Kaschak Winter 2015

PSU-KASCHAK-W15S2G20

5 Members

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 28

Past 30 Days: 146

All Time: 2,789