Introduction

Use this guide to replace or install RAM in your Toshiba laptop.

Power off the laptop.
  • Power off the laptop.

  • Disconnect the power cable from the laptop. If you do not, electric shock may result.

Add Comment

Flip the laptop over and orient it such that the battery faces towards you and the front faces away from you as shown in the diagram.
  • Flip the laptop over and orient it such that the battery faces towards you and the front faces away from you as shown in the diagram.

  • Unlock the battery by sliding the tab shown to the right.

    • This tab will latch into place.

Add Comment

Slide the tab shown to the left and remain holding it.
  • Slide the tab shown to the left and remain holding it.

    • This tab does not lock into place like in the first step.

  • Place your thumb on the grips of the battery as shown.

    • While holding onto the grips, pull the battery towards you and away from the laptop.

Add Comment

Loosen this 5 mm Phillips #0 screw found in the center of the lower case. Use the Phillips #0 screwdriver. The screw will not come out completely, it will stay connected to the center plate.
  • Loosen this 5 mm Phillips #0 screw found in the center of the lower case. Use the Phillips #0 screwdriver.

    • The screw will not come out completely, it will stay connected to the center plate.

Add Comment

Remove the center plate by lifting it and sliding it to the right.
  • Remove the center plate by lifting it and sliding it to the right.

  • If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that the screw is loose before attempting again.

Add Comment

The computer should be open with many of the internal components shown. You can now access the RAM, and wireless card.
  • The computer should be open with many of the internal components shown. You can now access the RAM, and wireless card.

Add Comment

Push the two white tabs away from the RAM. The left side of the RAM should pop out of its holder.
  • Push the two white tabs away from the RAM. The left side of the RAM should pop out of its holder.

Add Comment

Pull the RAM out of the dock by lifting it from the left side and sliding it towards the left.
  • Pull the RAM out of the dock by lifting it from the left side and sliding it towards the left.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Travis

Member since: 04/13/2013

13 Reputation

5 Guides authored

Team

Cal Poly, Team 10-38, Amido Spring 2013 Member of Cal Poly, Team 10-38, Amido Spring 2013

CPSU-AMIDO-S13S10G38

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 689