Parts

No parts required.

Introduction

This guide gives instructions on how to remove the disc drive front flap of the Toshiba SD-K740 DVD player.

Image 1/1: Remove the three .303 inch screws from the back panel using a #0 Phillips head screwdriver.
  • Make sure the DVD player is unplugged before beginning.

  • Remove the three .303 inch screws from the back panel using a #0 Phillips head screwdriver.

Add Comment

Image 1/2: Remove the .303 inch screw. Image 2/2: Now flip the DVD player onto its other side.
  • Turn the DVD player on its side.

  • Remove the .303 inch screw.

  • Now flip the DVD player onto its other side.

  • Remove the .303 inch screw from this side.

Add Comment

Image 1/1: Remove the back panel by lifting up and pulling it towards yourself.
  • Flip the DVD player over onto it's front face.

  • Remove the back panel by lifting up and pulling it towards yourself.

Add Comment

Image 1/1: Lift and push away each of the two tabs located in the middle of the player.
  • Flip the DVD player so its top is sitting on your working surface.

  • Lift and push away each of the two tabs located in the middle of the player.

  • The front panel will not come off during this step, so do not force it.

Add Comment

Image 1/1: Lift and slide forward a single tab on the side.
  • Flip the DVD player on its side.

  • Lift and slide forward a single tab on the side.

  • The front panel will not come off during this step, so do not force it.

Add Comment

Image 1/2: Image 2/2:
  • Grasp the front panel and pull forward and to your right to remove.

Add Comment

Image 1/2: There is just enough tolerance in the plastic to allow removal, be careful of brittle plastic. Image 2/2: There is just enough tolerance in the plastic to allow removal, be careful of brittle plastic.
  • On back side of front panel very carefully apply pressure to the left hand side of the flap hinge.

  • There is just enough tolerance in the plastic to allow removal, be careful of brittle plastic.

Add Comment

Image 1/1: Carefully remove the right peg from the restraint.
  • Once the peg is free from the left restraint, carefully remove the left part of the flap.

  • Carefully remove the right peg from the restraint.

  • Do not pull away from the front panel because the spring is still attached.

  • Do not force the plastic.

Add Comment

Image 1/1: Do not pull away from the front panel until the spring has been removed from the flap.
  • Remove the spring from the end of the right peg by pulling the door away from the spring.

  • Do not pull away from the front panel until the spring has been removed from the flap.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

John Lokker

Member since: 01/20/2011

304 Reputation

3 Guides authored

Team

Cal Poly, Team 1-16, Amido Winter 2011 Member of Cal Poly, Team 1-16, Amido Winter 2011

CPSU-AMIDO-W11S1G16

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 15

All Time: 1,050